mabe EML27WWF0 Service Manual page 67

Failures and solutions
PROBLEM
Surface units will not
maintain a rolling boil or
cooking is not fast
enough
Surface units do not work
properly
Surface unit stops
glowing when turned to a
lower setting
Scratches (may appear
as cracks) on cooktop
glass surface
Areas of discoloration on
the cooktop
Ingeniería de Servicio
POSSIBLE CAUSES
Improper cookware being
used.
In some areas, the power
(voltage) may be low.
A fuse in your home may
be blown or the circuit
breaker tripped.
Cooktop controls
improperly set.
This is normal. The unit is still on and hot.
Incorrect cleaning
methods being used.
Cookware with rough
bottoms being used or
coarse particles (salt or
sand) were between the
cookware and the surface
of the cooktop.
Cookware has been slid across the cooktop surface.
Food spillovers not
cleaned before next use.
67
WHAT TO DO
Use pans which are flat and match the
diameter of the surface unit selected.
Cover pan with a lid until desired heat is
obtained.
Replace the fuse or reset the circuit
breaker.
Check to see the correct control is set
for the surface unit you are using.
Scratches are not removable. Tiny
scratches will become less visible in
time as a result of cleaning.
To avoid scratches, use the
recommended cleaning procedures.
Make sure bottoms of cookware are
clean before use, and use cookware
with smooth bottoms.
See the Cleaning the glass cooktop
section.