Heat Sink - HP VR Backpack G2 Maintenance And Service Manual

Heat sink

Table 5-8 Heat sink description and part number
Description
Heat sink
Before removing the heat sink, follow these steps:
1. Prepare the computer for disassembly
2. Remove the top cover (see
3. Remove the fans (see
4. Remove the WLAN antenna (see
5. Remove the battery (see
Remove the heat sink:
1. Loosen eight captive retaining screws according to the numbered order stamped on the heat sink (1).
2. Lift and remove the heat sink (2).
Reverse this procedure to install the heat sink.
NOTE: When installing the heat sink, be sure to examine the areas where the components and the heat sink
come into contact to make sure the areas are properly covered by the thermal pads and paste.
26 Chapter 5 Removal and replacement procedures
(Preparation for disassembly on page
Top cover on page 14).
Fans on page 16).
WLAN antenna on page
Battery on page 24).
Spare part number
L62397-001
14).
21).