Computer Setup (Bios) And Tpm; Using Computer Setup; Starting Computer Setup; Navigating And Selecting In Computer Setup - HP VR Backpack G2 Maintenance And Service Manual

7

Computer Setup (BIOS) and TPM

Using Computer Setup

Computer Setup, or Basic Input/Output System (BIOS), controls communication between all the input and
output devices on the system (such as disk drives, display, keyboard, mouse, and printer). Computer Setup
includes settings for the types of devices installed, the startup sequence of the computer, and the amount of
system and extended memory.
NOTE: Use extreme care when making changes in Computer Setup. Errors can prevent the computer from
operating properly.

Starting Computer Setup

Turn on or restart the computer, and when the HP logo appears, press
▲

Navigating and selecting in Computer Setup

To select a menu or a menu item, use the
●
use a pointing device to select the item.
To scroll up and down, select the up arrow or the down arrow in the upper-right corner of the screen, or
●
use the up arrow key or the down arrow key on the keyboard.
To close open dialog boxes and return to the main Computer Setup screen, press esc, and then follow
●
the on-screen instructions.
To exit Computer Setup, choose one of the following methods:
To exit Computer Setup menus without saving your changes, select Main, select Ignore Changes and
●
Exit, and then select Yes.
NOTE:
To save your changes and exit Computer Setup menus, select Main, select Save Changes and Exit, and
●
then select Yes.
NOTE:
Your changes go into effect when the computer restarts.

Restoring factory settings in Computer Setup

NOTE: Restoring defaults will not change the hard drive mode.
To return all settings in Computer Setup to the values that were set at the factory, follow these steps:
1. Start Computer Setup. See
2. Select Main, select Apply Factory Defaults and Exit, and then select Yes.
NOTE:
NOTE:
Defaults and Exit.
38 Chapter 7 Computer Setup (BIOS) and TPM
If you are using arrow keys to highlight your choice, you must then press enter.
If you are using arrow keys to highlight your choice, you must then press enter.
Starting Computer Setup on page
If you are using arrow keys to highlight your choice, you must then press enter.
On select products, the selections may display Restore Defaults instead of Apply Factory
tab key and the keyboard arrow keys and then press enter, or
38.
f10 to enter Computer Setup.