Technical Data - Fieldmann FZR 2020-E Manual

Interrupted
lawnmower operation
Engine is "Choking"
Cutting blade will not
rotate
Extremely strong
vibrations / Excessive
noise during operation
16. TECHNICAL SPECIFICATIONS
Lawnmower .............................................................................................................................................. FZR 2020-E
Rated voltage .............................................................................................................................................230 - 240V
Rated frequency ................................................................................................................................................. 50 Hz
Rated input.......................................................................................................................................................... 1 200 W
Idle operation ..............................................................................................................................................3300 rpm.
Width of cut .................................................................................................................................................... 320 mm
Weight ................................................................................................................................................................... 9.5 kg
Guaranteed sound pressure level ..........................................................................79.2 dB(A) KpA:3.0 dB(A)
Guaranteed sound power level ............................................................................................................... 96 dB(A)
Vibrations.................................................................................................................................2.50 m/s
Instructions Manual - language version only.
ELECTRIC LAWNMOWER
Possible problems and troubl shooting | Technical specifications
Damaged extension cable,
Damaged internal wiring
Engine protection activated,
Engine protection activated
Cutting height adjustment too
low
Dull cutting blade
Clogged lower part of the
lawnmower
The cutting blade is attached
the other way round
The blade is jammed
Loose blade holder bolt
Loose nuts / bolts Damaged
cutting blade
Check the cable and replace it if
necessary. Contact the Customer
Service Let the lawnmower cool
down for a few minutes and then
increase the cutting height
During this time do not operate the
switch lever 1
as this will prolong the time to
automatically
reset the safety cut-out
Increase the cutting height (see
Cutting Height Adjustment)
Replace the cutting blade (see
Cutting Blade Maintenance) Clean
the lawnmower (see Storing the
Lawnmower) Remove the blade and
attach it correctly (see Cutting Blade
Maintenance)
Dislodge the blade Tighten the bolt
Tighten the nuts / bolts Replace the
blade
OPERATING INSTRUCTIONS
19 EN
K 1.5 m/s
2 2