Advertisement
What is included in you SpeedZone® Te a m
p a c k a g e :
1. SpeedZone® Team Computer (1)
2. Mounting bracket (2)
3. Magnet with screw (1)
4. Cable tie wraps (4)
1
5. Mounting bracket sizing straps (3)
6
6. Transmitter (1)
2
7. Transmitter mounting bracket (1)
Mounting the SpeedZone® Te a m :
The SpeedZone® Team Wi reless transmitter can
7
mount on the right or the left side of the fork blade.
3
The right side should be used on large frames or
when a suspension fork is installed. The optimal dis-
tance between the computer and the transmitter is 24
5
inches (610mm) The distance may need to be less that
24 inches (610mm) if ambient temperatures are
below 40 °F (4 °C). To reduce signal loss in colder
t e m p e r a t u res, the transmitter should be mounted as
close to the computer as possible. (maximum mount-
ing distance is 28 inches). Use the transmitter mount-
4
ing bracket and tie-wraps provided to position the sen-
s o r. Do not tighten the tie-wraps until final placement
2
2 4 i n .
m a x
1 - 2 m m
f i g . 1
f i g . 2
of the magnet is correct. See figure 1.
Attach the magnet to a spoke across fro m
the transmitter with the magnet scre w. The
clearance between the magnet and the
transmitter should be approximately 1 / 3 2 " -
1/16" (1-2mm). Tighten the magnet and
t r a n s m i t t e r. Do not over-tighten the magnet
s c rew See figure 2.
Attach the mount to the handlebar using the
bracket screw provided. Tighten so that the
bracket cannot rotate on the handlebar.
T h e re are several sizing straps provided to fit
d i ff e rent diameter bars See figure 3.
the computer forw a rd onto the mounting
until it 'snaps' into place with an audible
click. To remove the computer, push it back-
w a rd until it releases from the mount. To test
for proper installation of the magnet, trans-
mitter and computer, activate the computer
by pushing the 'MODE' (right side) button
and pick up the front of the bicycle and
spin the wheel. The "wheel option" indica-
f i g . 3
tor will flash. If it does not flash, check the
sensor and magnet alignment. Realign as
n e c e s s a ry until the "wheel option" indicator
flashes while spinning the wheel.
3
Advertisement
