CoolLED pE-100 Series Quick Start Manual

Hide thumbs Also See for pE-100 Series:

pE-100 series

Quick Start Guide

This guide should provide some basic information on the setup and operation

of the CoolLED pE-100 Illumination System.

Before operating this product please read and observe the advice given in the

safety section of the full User Manual.

For more detailed information on the full range of options and functions

please see the full User Manual.

DOC-015 Iss 1

Table of Contents

Need help?

Do you have a question about the pE-100 Series and is the answer not in the manual?

Page 1 Quick Start Guide This guide should provide some basic information on the setup and operation of the CoolLED pE-100 Illumination System. Before operating this product please read and observe the advice given in the safety section of the full User Manual.
Page 2 The fibre version of the pE-100 is a fixed module that allows connection to any SMA terminated fibre. An appropriate fibre can be ordered through CoolLED if required. 2. Fitting the Light Source to a microscope Epi-Fluorescent port Transmitted (Brightfield) port Attach the Light Source to the specified port of the microscope (Direct fit).
Page 3 3. Connecting the Control Pod and power supply Connect the Control Pod cable with the D- type connector to the Light Source. Secure the connector in place with the screws, using a flat-headed screwdriver. Insert the connector from the power supply into the Control Pod as shown.
Page 4 4. Control Pod operation Excitation intensity level (%) On/Off status Light Source wavelength (nm) Intensity control buttons On/Off button 5. Optical adjustment (direct fit version) To optimize the Light Source set Thumbscrew up a sample that covers the entire field of view. Loosen the thumbscrew and slide the Light Source back and forth whilst viewing the sample.