Advertisement
pE-100 Troubleshooting Guide
Contents
1)
The Illumination System doesn't power up (nothing appears on the
Control Pod). .................................................................................. 2
2)
No Light Is Illuminating The Sample. ................................................. 2
3)
The Illumination Appears Weak. ...................................................... 3
4)
5)
Illumination Is Not Centralized Over The Field Of View. ..................... 3
6)
Image Of The Leds On The Sample. ................................................... 3
7)
CoolLED contact information .......................................................... 4
DOC-016 Iss 1
1
Advertisement
Table of Contents
Related Manuals for CoolLED pE-100
Summary of Contents for CoolLED pE-100
- Page 1 Illumination is not flat and even at the sample (homogenous)..3 Illumination is not centralized over the field of view...... 3 Image of the LEDs on the sample............ 3 CoolLED contact information ............4 DOC-016 Iss 1...
- Page 2 Confirm that any shutters are open and that the filter sets are compatible with the excitation wavelengths being used. If the LEDs are not illuminating then the system will need to be returned to CoolLED for investigation. DOC-016 Iss 1...
- Page 3 Has the optical setup procedure been carried out (shown in Section 7 of the User Manual)? Is the pE-100 being used with any additional parts that may increase the optical path length? For example an external shutter or a pE-Combiner. DOC-016 Iss 1...
- Page 4 If the advice in this document has been unable to solve your issue, or the issue that you are experiencing is not listed then please contact the CoolLED support team at support@coolled.com. They will be able to offer further advice and explain the repair procedure.
Need help?
Do you have a question about the pE-100 and is the answer not in the manual?
Questions and answers