Mira Moto Installation & User Manual page 18

Screw
Retaining Ring
30.Check that the blue 'O' seal is fitted inside the
backplate nut. Fit the olive and the backplate
nut over the outlet pipe and loosely tighten
the nut.
31. To prevent the backplate from turning while
tightening the nut, fit the retaining ring over the
backplate nut making sure the slots engage
with the screws on the backplate, hold the
retaining ring with a wrench while tightening
the backplate nut. Remove the retaining ring
after use.
32. Check that the second 'O' seal (black) is fitted
to the outside of the backplate nut. Press the
elbow onto the backplate, make sure that the
clips on the elbow engage with the backplate.
33. Slide the retaining ring over the elbow and
engage with the elbow clips. Note! The
retaining ring must be engaged correctly to
lock the elbow to the backplate, rotate the
retaining ring to the postition illustrated.
Olive
Backplate Nut
Slot
Elbow
34. Press the shroud over the elbow, make sure
that it engages with the lugs on the backplate.
35. Fit the concealing ring over the mixer and mark
the positions of the three fixing holes.
36. For solid walls drill three 6 mm holes for the
wall plugs. For other types of wall structure
alternative fixings may be required (not
supplied).
Caution! Make sure that you do not drill into
pipework in the wall.
Concealing Ring
Apply Silicone
Sealant
37. Insert the wall plugs (supplied) and attach the
concealing ring to the wall with the screws
provided.
Important! Apply silicone sealant to the
groove on the rear face of the concealing ring
38. Fit the concealing plate to the concealing ring.
39. Refit the control knobs.
40 Fit the shower fittings, refer to your shower
fittings installation and user guide for
instructions.
Important! For high pressure systems (above
0.5 bar) make sure that the flow regulator
(supplied) is fitted, refer to section: 'Flow
Regulators'.
41. Turn on the hot and cold water supplies and
check for leaks.
42. Before using the shower, refer to section:
'Commissioning'.
18
Retaining Ring shown
correctly engaged with
Elbow
1
2
Screws