Mira Moto Installation & User Manual page 12

9. For Rear Entry Supplies Only:
a) Fit the concealing plates over the inlet
pipes.
Note! Apply silicone sealant to the back
face of the flange.
Apply Silicone Sealant
10. Caution! It is essential at this point
that the supply pipework is thoroughly
flushed through before connection to the
mixer. Failure to do so may result in product
malfunction and will not be covered under the
guarantee.
11. Fit the compression nuts and olives onto the
pipework.
12. Align the mixer with the pipework and fit onto
the backplate.
Important! Make sure that the hot and cold
inlets on the mixer correspond with the hot and
cold inlet supplies.
13. Tighten the compression nuts onto the mixer
with a suitable wrench.
Caution! Take care not to damage the chrome
surfaces.
14. Tighten the grubscrew to secure the mixer to
the backplate.
Concealing Plate
Compression Nut
Olive
15. Fit the shower fittings, refer to your shower
fittings installation and user guide for
instructions.
Important! For high pressure systems (above
0.5 bar) make sure that the flow regulator
(supplied) is fitted, refer to section: 'Flow
Regulators'.
16. Turn on the hot and cold water supplies and
check for leaks.
17. Before using the shower, refer to section:
'Commissioning'.
12