Mira Moto Installation & User Manual page 14

Built-in Thermostatic Mixers
1. Carefully remove the concealing cap from the
control knob.
2. Unscrew the grubscrew using a 2.5 mm
hexagonal key (supplied) and pull off the
control knob(s).
Note! The flow control knob must be in the off
position in order to remove it.
Flow Control Knob
Grubscrew
Concealing Cap
3. Carefully remove the concealing ring from the
concealing plate.
Concealing Plate
Control Knob
Grubscrew
Concealing Cap
Temperature
Control Knob
Concealing Ring
4. Determine the route for the hot and cold
supply pipework and for the outlet pipework.
When connecting to the BIV shower fittings it
is recommended that the outlet be positioned
to one side of the mixer. This is to prevent
the flexible hose from obstructing the shower
controls (refer to illustration).
Alternative Pipe layouts
Thermostatic
Mixer
Hot Inlet
5. Mark the routes for the hot and cold supply
pipework at 103 mm centres (Hot - Left, Cold
- Right).
Note! If it is not possible to install the
mixer with this pipework configuration follow
instruction 6.
Falling Supplies: For falling supplies loosen
the grubscrew on each elbow using the 2.5 mm
hexagon key (supplied). Remove the elbows
and install on opposite sides.
Important! Make sure that the elbows are
pushed fully onto the mixer before tightening
the grubscrews, do not overtighten.
14
Outlet Pipe BIV
Cold Inlet
103 mm
Outlet Pipe BIV