Running The System / Quick Start In 5 Steps; Taking Out Of The Packaging; Connections; Switching On - Viessmann Commander 5300 Quick Start Manual

i
14
Running the system /
Quick start in 5 steps
The intuitive operational-concept makes
it really easy to work with the Comman-
der. The following fi ve steps show you how
quickly you will be enabled to control your
trains with the Commander. We wish you
much fun and success with the new
Commander!

1. Taking out of the packaging

Be careful while taking out the Commander
of the packaging. Acquaint yourself with
the elements of the control panel
illustrated on page 6.

2. Connections

Notice:
the polarity of the track connections is
irrelevant for DCC-systems.
Using the Märklin Motorola format,
please be mindful of the right polarity,
otherwise older decoders may not work
correctly. Follow the illustration.
• Connect the track output of the
Commander to the track connection of
your layout.
• Connect the programming track output
of the Commander to the programming
track connection of your layout.
• Connect the power supply to the
Commander and then to a proper
plug socket.

3. Switching On

You must press the on / off pushbutton on
the top right of the device till it is illumina-
ted green to switch on the Commander.
This will take approx. 1-2 seconds.
The Commander boots up now.
After that, the Commander is in the mode
"locomotive and track diagram" and the
display shows an exemplary track
diagram. As standard displaying mode a
locomotive is already assigned to each of
the two control panels.
4. Put the locomotive
on the track
Put a digital locomotive on the program-
ming track. The Commander will
automatically identify the engine.
A window "train identifi cation" opens up
and the digital address of the locomotive
standing on the programming track is indi-
cated. (see illustration on the right side).
Quick Start