Table of Contents
Advertisement
Commander Reference Manual
1.1.1.5 Running a train
Multiple-unit running (multiple heading)
Introduction
The Commander is equipped for the multiple hea-
ding-function. The traction of the train is accomplis-
hed by several coupled locomotives then, e.g. in
case of heavy traffic. Normally, locomotives off the
same design series with equal running qualities are
used for this purpose. This should be a guideline
on your layout too, in order to achieve an equaliza-
tion of weight.
Application
The set up of the multiple heading is done by the
additional function menu of the leading locomotive.
But first you should shunt and couple the respec-
tive engines on the rail.
The Commander allows you to couple up to 5 trac-
tion units. One of them is the leading locomotive.
The control panel of the leading locomotive visua-
lizes a programmed multiple heading by an indica-
tion below the icon of the leading locomotive. You
will see an "M" followed by the number of additio-
nally participating locomotives.
All other locomotives coupled to this multiple hea-
ding will show the indication "MT" (see illustration
on the next page).
Multiple heading editor for up to 5 locos
Commander Reference Manual version 1.0 from 2009-12-03, page 11
Multiple heading editor
The set up of a multiple-unit running is exe-
cuted via the control panel of the leading lo-
comotive. You call up the multiple heading
editor in the additional function menu of the
leading locomotive by pushing the symbol
represented down below.
Note:
All participating locomotives should work with
the same digital format. If using the DCC-
format they should also be adjusted to the
same speed steps. Otherwise you will have
an error message.
1.1.1.5
Advertisement
Table of Contents
