Table of Contents
Advertisement
Survey of the Commander
Schematic overview of the
Commander and the touch fields
To start with, you will find a schematic
overview of the Commander and the touch
fields on the left side.
On/Off and Emergency Stop
You switch the Commander on and off with
this pushbutton. Additionally you can
activate two different emergency stop
functions. The operating status of the
device is indicated by the illumination of
the pushbutton
Button
Function (explication)
Off
Device is off
blinking
Device is starting
green
green
Device switched on,
normal operating mode
blinking
Device switched on, emer-
red-green
gency stop, track power on
red
Device switched on, emer-
gency stop, track power off
blinking
Shutdown
red
Viessmann Commander
Switching the Commander
on and off
Switching on:
Push the pushbutton until it´s blinking
green (approx. 1-2 seconds).
Switching off:
Hold down the pushbutton until the illumi-
nation is switched off (> 3 seconds).
The display gets darker until it goes com-
pletely out.
Emergency stop 1:
This emergency status stops automatically
all trains. The track power is still on.
• To activate the emergency stop 1, press
shortly the on/off emergency-push-
button. To deactivate the emergency
stop press the pushbutton shortly.
• Letting loose the pushbutton the emer-
gency stop is deactivated and the
illumination is green again.
Emergency stop 2:
This emergency status stops automatically
all trains and cuts off the track power.
• To activate the emergency stop 2, press
the on/off emergency-pushbutton till the
illumination is permanently red.
• To deactivate the emergency stop press
the pushbutton shortly again.
7
Advertisement
Table of Contents
