Draining The Brewer - Keurig K-1500 Use & Care Manual

Draining the Brewer

The hot water tank of these brewers can be completely drained. We recommend that the brewer be drained if it is to be
transported or stored for an extended period of time.
1. Turn off the brewer, unplug it, and allow the brewer to cool
approximately 90 minutes.
2. Remove and empty the water reservoir.
3. Turn the brewer around so the back is facing a sink or an
area where the water will be drained.
4. Remove the door on the back of the brewer by pressing
down on the door clip.
5. Remove the drain tube from within the compartment and
carefully remove the plug from the end of the tube while
pitching the tubing and pointing it towards the sink or
larger pitcher (18oz or larger).
6. Over a sink or large pitcher, drain the water from the
internal hot water tank into the pitcher.
CAUTION: If the brewer was not allowed to cool sufficiently, the water draining from the tube
may be very hot.
7. Re-cap the tube.
NOTE: To avoid losing parts, when finished, re-insert the tube and close the panel door.
Backside of Brewer (drain line access)
Door
Clip
Drain line access
door (closed)
Plug
Drain line tube
(door open)