Keurig K-1500 Use & Care Manual page 2

Before You Brew
1
Plug & Place
Remove packing tape from
brewer and plug into a
grounded outlet.
Place a large mug (12oz
minimum) on the drip
tray plate.
3
Power On
Press power button —
the white power light
will illuminate.
The brewer will automatically
begin heating the water. This
will take about 3 minutes.
Once the heating sound
stops, the brewer is ready.
2
Rinse & Fill
Remove the water reservoir
lid, then lift the reservoir
straight up to remove it.
Rinse reservoir with fresh water
and fill to the MAX fill line.
Replace water reservoir, making
sure the lock tab engages with
the brewer. Replace lid.
NOTE: Do not use distilled water.
4
Cleansing Brew
3
Do not insert a K-Cup
Open and close the bail.
The brew size and STRONG
buttons will blink. Press the
8oz button and then the Brew
button to start a cleansing
brew. Pour the hot water
into the sink.
The one-time setup process
is now complete and you are
ready to brew!
NOTE: Between brew cycles, the brewer may take
about a minute to reheat.
pod.
®