Using The Menu Bar And The Pulldown Menus - Texas Instruments TMS370 Series Getting Started Manual

Using the Menu Bar and the Pulldown Menus

2.3 Using the Menu Bar and the Pulldown Menus

In addition to the command window, the programmer has a menu bar, which
gives you an alternative method for entering many of the programmer com-
mands. The menu bar is at the top of the display.
All of the selections on the menu bar have pulldown menus; if they could all
be pulled down at once, they'd look like this:
There are several ways to display the pulldown menus and then execute your
selections from them. Executing a command from a menu has the same effect
as executing a command by typing it in.
-
-
If you display a menu and then decide that you don't want to make a selection
from this menu, you can do one of the following:
-
-
2-4
Load Memory
Load Add
Delete
Reset
List
Fill
Save
To use the pulldown menus with a mouse, follow these steps:
1) Point the mouse cursor at one of the menu-bar selections.
2) Click the left mouse button. This displays the menu until you are ready
to make a selection.
3) Point the mouse cursor at your selection on the pulldown menu.
4) When your selection is highlighted, click the left mouse button.
To use the pulldown menus with the keyboard, follow these steps:
1) Press the key; don't release it.
ALT
2) Press the key that corresponds to the highlighted letter in the selection
name; release both keys. This displays the menu and freezes it.
3) Press and release the key that corresponds to the highlighted letter of
your selection in the menu.
Press
ESC .
Point the mouse outside of the menu; press and then release the left
mouse button.
Color
Prog
Load
Device
Save
Program
Config
Verify
Border
Upload
Prompt
Blank Check