Logging Out Of The Web Ui Of The Wireless Bridge - HIKVISION DS-3WF01C-2N/O User Manual

Log in to the web UI successfully. Now you can configure the wireless bridge.
If the login page does not appear, try the following solution:
 Check whether the wireless bridge is powered on properly, and the computer is connected to
the wireless bridge properly.
 Check whether the IP address of the computer is set to 192.168.1.X (X ranges from 2 to 254,
excluding 36).
 Reset the device and refer to the quick start guide to configure it again.
Reset method: After the device is powered on for about 1 minute, hold down the RST button
for about 8 seconds, then release it. When all the LED indicators light up, the device is restored
to factory settings.
2.2

Logging out of the web UI of the wireless bridge

Click the Logout on the upper-right corner of the web UI to logout. When you close the web
browser, the system logs you out as well.
DS-3WF01C-2N/O User Guide
8