Table of Contents
Advertisement
6.1. b
M
oard
aintenance
•
It is recommended to rinse the jet with fresh water after every use.
When using in extreme saline environments, it´s recommendable to flash
the entire intake area with fresh water. This way the user will get rid of all
the excessive salt in the shaft and impeller.
•
Do not leave the batteries connected. To disconnect is, it´s necessary to
take it out of the board. The batteries powe the board from the monment
it´s inserted. Although the power consumption is very low, it is not
recommendable to leave it inside for long periods.
•
Clean the staliness steel tube frequently. With every use, a small layer
of salt could build up over the surface. Given that the tube´s surface is in
charge of heat dissipation, it´s extremely important to have it clean for a
proper dissipation.
•
It is not recommendable to place it upside down and never exposed to
direct sunlight over long periods of time.
•
Periodically apply grease on the impeller, stator/nozzle.
•
Between uses, always keep the discharge connectors clean.
•
Do not impact the turbine or rest the board over it.
M
aintenance of the
6.2. b
M
attery
aintenance
•
It is crucial to handle the batteries correctly while having it outside
of the board. In case of dropping it and due to its large weight, the
watertight seal could break. Do not use the batteries if they have been
dropped and contact the support team inmediately.
•
For long lasting storage, it's recommended to frequently recharge it (every
1 or 2 months) always keeping the capacity below 20%.
•
In case of break, dint or any other form of apparent damage, do not
use the battery.
•
It is recommendable to store the batteries in a dry place and not exposed
to direct sunlight.
•
Do not submerge the batteries.
•
Do not throw the batteries away. The batteries must be properly
destroyed at recycling facilities.
06
e
quipMent
CARVER USER'S MANUAL
21
Advertisement
Table of Contents
