Table of Contents
Advertisement
04
U
C
se and
onfigUration of the
on the controller beings to blink. At
this moment, the LED bar will begin to
progressively light up. Each position
represents
a
different
) S
. 1
a
hynchronization
Once the first LED begins to blink, you
must press on the drop again to access the submenu.
In this submenu, the controller will begin to search for a board for a few
seconds and the sync LED will begin to blink.
As the sync LED is blinking the battery must be inserted to complete
the synchronization (see 4.1.2.).
Once the board is synched, both LEDs will blink at a higher pace
indicating that the process has been successfully completed.
) M
P
. 2
b
axiMuM
ower
LedS
Once that the first two LEDs are
flashing you must press on the
drop to access this submenu.
The power bar will progressively light up. Press on the drop to set
the desired value according to the following description.
14
CARVER USER'S MANUAL
e
qUipment
2
function.
b
St Led
Linking
b
Linking
LEDs
1 LEDs
SYNC
BATTERY
2 LEDs
LED Blinking
3 LEDs
4 LEDs
5 LEDs
) c
c
ontroLLer SenSitivity
Once the first three LEDs are flashing you must press on the drop to
access the submenu.
The power bar will progressively light up. Press on the drop to set
the desired value according to the following description.
• 1 LED:
• On
this
the jet in 5 different ranges of pressure on the drop. It
SYNC
BATTERY
allows us to control and hold the pressure on each range.
100
80
60
40
20
0
Low
Power [W]
1.500
2.300
5.100
7.400
Factory Settings
10.000
. 3
b
LedS
Linking
Staggered 1.
profile
we
have
discretized
Staggered 1
Medium
Display
the
power
levels
of
High
Advertisement
Table of Contents
