Table of Contents
Advertisement
5.3. F
irSt uSe
5.3.1. S
tart uP
During first uses it is recommendable to use it on your knees.
1. Get on top of the board with the leash attached and the magnetic
key connected. You should place your knees on each side of the front
footstrap.
2. After being positioned, press on the drop to activate the jet.The power
will vary depending on the pressure being put on the drop.
3. Once you gain speed you can progressively stand on it.
Make sure not to accidentally press on the drop while getting on or off
the board.
5.3.2. t
urn
Before
turning,
make
sure
and
not
interfere
with
the
Shift the weight towards the side where you intend to turn to ease the
movement. The more speed, the easier it is to turn. The board turns like a
conventional board.
there
is
enough
space
to
trajectory
of
any
other
5.4. g
etting out oF the water
•
Do not activate the jet outside of the water. The propulsion system is
not meant to be used outside of the water, this could significantly damage
the jet.
•
After a long use going full thrust, it´s recommendable to wait at least
one minute for the jet not to overheat.
•
When the jet reaches high temperatures, an inner fan is automatically
activated for heat dissipation purposes. In order for this process to be
done appropriately, the jet must be in contact with the water.
•
It is not recommendable to step on the battery surface. Although
it's designed to hold weight, when stepping on it, the watertight seal
compresses facilitating water to get in.
do
so
vehicle.
05
S
G
afety
uidelineS
CARVER USER'S MANUAL
19
Advertisement
Table of Contents
