Mounting Kit "Linear Actuator" 6Dr4004-8V And 6Dr4004-8L - Siemens SIPART PS2 6DR50xx Manual

3.3.3 Mounting kit "linear actuator" 6DR4004-8V and 6DR4004-8L

Ser. no. pieces Designation
1 1 NAMUR mounting kit bracket
IEC 534
2 1 Pick-up bracket
3 2 Clamping assembly
4 1 Carrier pin
5 1 Roll
6 1 Lever NAMUR
7 2 U bolt
8 4 Hexagon head screw
9 2 Hexagon head screw
10 6 Lock washer
11 6 Flat washer
12 2 Flat washer
13 1 Spring
14 1 Spring washer
15 1 Lock washer
16 3 Spring washer
17 3 Socket cap screw
18 1 Hexagon nut
19 1 Square nut
21 4 Hexagon nut
Table 3-1 Scope of delivery of the mounting kit "linear actuator"
SIPART PS2 Manual
A5E00074631--06
The scope of delivery of the mounting kit "linear actuator IEC 534
(3 mm to 35 mm)" are contained (ser. no. see figure 3-7, page 51):
Note
Standardized connection for mounting console with
ledge, column or plane surface
Guides the roller with carrier pin and turns lever
arm
Mounting of pick-up bracket on actuator spindle
Assembly with roll (5) on lever (6)
Assembly with driver pin (4) on lever (6)
For stroke range 3 mm to 35 mm
For stroke ranges> 35 mm to 130 mm (special deli-
very), lever 6DR4004-8L is required additionally
Only for actuators with columns
M8 x 20 DIN 933-A2
M8 x 16 DIN 933-A2
A8 -- DIN 127-A2
B 8,4 -- DIN 125-A2
B 6,4 -- DIN 125-A2
VD--115E 0.70 x 11.3 x 32.7 x 3.5
A6 -- DIN 137A-A2
3.2 -- DIN 6799-A2
A6 -- DIN 127-A2
M6 x 25 DIN 7984-A2
M6 -- DIN 934-A4
M6 -- DIN 557-A4
M8 -- DIN 934-A4
Preparing for Operation
49