Mechanical Fitting - Bartec POLARIS SMART HMI 17-71V6-1 Series User Manual

Installation
6.2.2

Mechanical fitting

EN 22/54
POLARIS SMART HMI
POLARIS Smart HMI 7" W
Work steps
(1) Insert the POLARIS into the cut-out in the enclosure.
(2) From the back, place the reinforcement frame over the POLARIS.
(3) Using the M4x12 (2) screws to fasten the mounting clamps (1) to the rear side of the
POLARIS and tighten to 1.3 Nm.
(4) Tighten the clamping screw (3) of the mounting clamps to a torque of 1.0 Nm.
Number of retaining claws
POLARIS SMART HMI 7"
Always tighten the mounting clamps crosswise.
- for Zone 1/21
4 pieces
Technical data subject to change.
04/2018