Rockwell Automation Allen-Bradley 1756-EWEB Installation Instructions Manual page 14

14 EtherNet/IP Web Server Module
Connect the Module to the EtherNet/IP Network
WARNING
Attach the RJ45 connector to the EtherNet/IP port on the bottom of the
module as shown below:
RJ-45 EtherNet/IP
connector
This is the bottom, back of the module that
connects into the chassis.
Publication
1756-IN588A-EN-P - February 2004
If you connect or disconnect the communications
cable with power applied to this module or any device
on the network, an electrical arc can occur. This could
cause an explosion in hazardous location installations.
Connect the cable
here.