GE DGP Series Instruction Manual page 258

B.1 CHANGE NOTES
Table B–3: ADDITIONS TO DGP MANUAL GEK-100666C (Sheet 2 of 2)
PAGE IN
GEK-100666B
4-25 Added the following to Step 4 of the T13 procedure of Section 4.7.10:
B
4-25 Added the following note to the T13 procedure of Section 4.7.10:
VA, VB, and VC must change from 70 V rms to 29 V rms with the source voltage continuously on.
4-30 Added a column for Frequency in Table 4-6: VOLTAGE INPUTS FOR TEST T16
--- Added FREQUENTLY ASKED QUESTIONS Appendix
Table B–4: ADDITIONS TO DGP MANUAL GEK-100666B
PAGE IN
GEK-100666A
1-3 Figure 1-1: TYPICAL WIRING DIAGRAM
1-3 Figure 1-2: SINGLE LINE DIAGRAM
8-2 Figure 8-1: TARGET LEDS
8-2 Figure 8-2: MMI KEYPAD
9-4 Section 9-2: MODBUS COMMUNICATIONS
--- Chapter 10: GE-LINK SOFTWARE
--- Appendix A: TABLES AND FIGURES
--- Appendix B: CHANGE NOTES
--- Appendix C: DGP WARRANTY
--- Added an Index
--- Reference to GE Power Management Website on back page
B-
2
"Set the current inputs according to the Table below:
Table 4–4: CURRENT INPUTS FOR TEST T13
PHASE A
MAG. PHASE
0.45 (0.09) A 0°
DGP Digital Generator Protection System
ADDITION
(to GEK-100666C)
PHASE B
MAG. PHASE
0.45 (0.09) A –120°
ADDITION
(to GEK-100666B)
APPENDIX B
PHASE C
MAG. PHASE
0.45 (0.09) A –240°
GE Power Management