Table of Contents
Advertisement
10 GE-LINK SOFTWARE
10 GE-LINK SOFTWARE 10.1 INTRODUCTION
The Settings and Station Generator ID will have the same register map as described in previous sections. The
model number can be written into registers 0000 to 000FH. Normally the model number registers are Read
Only registers. The only exception where they can be written are by. using factory command
a) HARDWARE
•
Minimum: X86 – based PC (Pentium or higher is recommended).
•
High performance multiple serial port board. The driver for the serial board should be pre-installed
and configured (the system has been tested with the Equinox AT serial interface boards and also
with the standard COMM ports of the PC).
•
If a modem is used, it should be installed and the driver should be TAPI compatible.
b) SOFTWARE
•
Windows NT 4.0 (SP 3 or later) or Windows 95/98.
•
Minimum of 32 MB RAM.
•
If a modem is used for communications, the modem driver must be installed and functional.
•
PKZip software for GE-Link file extraction.
1. Insert the GE Power Management Products CD into your local CD-ROM drive or point your web browser to
the GE Power Management website at www.GEindustrial.com/pm. Under Windows 95/98, the Products
CD will automatically launch the welcome screen. Since the Products CD is essentially a "snapshot" of the
GE Power Management website, the installation procedures from the CD and the web are identical.
2. Click the Index by Product Name item from the main page and select DGP Digital Generator Protection
from the products list to open the DGP products page.
3. Click the Software item from the Product Resources list to go to the 745 software page.
4. The latest version of GE-Link will be listed, along with additional installation instructions and release notes.
Click on the GE-Link Version 2.0 (supports DGP) menu item to download the installation program to your
local PC. Run the installation program and follow the prompts to install the software in the desired direc-
tory. When completed, a new GE Power Management group window will appear containing the GE-Link
icon.
GE Power Management
DGP Digital Generator Protection System
10.1 INTRODUCTION
10.1.1 OVERVIEW
10.1.2 SYSTEM REQUIREMENTS
10.1.3 INSTALLATION
10
10-
1
Advertisement
Table of Contents
