Midland BTNEXT PRO Instruction Manual page 9

1. Turn off the unit
2. Press and hold down the middle button about 7 sec., until the Red light is on permanently.
3. Now press one of the three buttons (Forward, Middle or Backward) for 3 seconds depen-
ding on which button you would like use to open the intercom to the other unit. The Blue
and Red lights will flash.
4. Repeat the same procedure on the other unit, you don't need to use the same button, you
can choose one of the three buttons not previously used.
5. When successfully paired, each unit will have the Blue light on for one second and then go
back to the setup mode (Red light always on).
6. Now the unit is ready for another pairing procedure, and you can pair another Midland
BTNEXT PRO unit following the same procedure, but using a different button.
If you don't have more devices to pair, you must exit the setup mode before you can use the units:
› Double click on the Middle button, the Red light will turn off and the Blue light will start
flashing. You can use now your Midland BTNEXT PRO
How to use the Intercom with more than two units
To use the intercom feature, be sure that all the units are turned on and correctly paired
together.
Manual activation in Intercom mode
When in "Intercom Mode" press the button corresponding to the unit you would like to
communicate with. After some seconds the intercom communication will open. The com-
munication remains active until you press again the same button. To quickly open the inter-
com to another person, just press the button corresponding to the other unit, the intercom
will be automatically closed and the new connection will be open (see Table A).
Voice activation (VOX)
The voice activation feature can open the intercom only to the unit paired to the Middle
button.
Hint: this feature is very useful when you have a specific person that you like to talk to more
often (for example your passenger). In this way you don't need to press a button to open the
communication.
Unit already busy in a conversation
If you try to open an intercom connection to another person that is already talking with
www.midlandeurope.com
some one else (or is in a middle of a phone conversation), you will hear a "busy" double
beep tone. Just wait sometime and try again, maybe this time the "line" is not busy.
The person who is called, will be advised that someone is trying to call and will hear a voice
announcement with the number of the button from which the request is coming.
In this way as soon as the first conversation is over, the person can easily contact the caller by
opening the intercom of the specific button number (indicated by the voice announcement).
1
Conference
The "Conference" mode allow the simultaneously communication between 4 people or,
if you pair a intercom device also on VOL-, up to 8 people (4 couple). You can decide to
use the BTNext Pro in "one to one" communication up to 6 people ("classic" Intercom
mode) or with 8 people (4 couples) conference intercom (Conference mode).
How to use the conference mode
First of all you need to pair all the units in a "chain" mode, second the "Conference"
feature must be active on all the units paired.
Pairing
To use the conference mode you need to pair all the units in a "chain" configuration. The
BWD button of the first unit must be paired to the FWD button of the second unit. The
BWD button of the second unit must be paired to the FWD button of the third unit and
so on, till the fourth!
1 2
2 3
3 4
27