Pairing The Midland Btnext Pro To Bluetooth Devices - Midland BTNEXT PRO Instruction Manual

The BTNEXT PRO is compatible with the previous line of Midland BT (BT Next, BTX2
and BTX2) only if updated to firmware version 2014 or later.

Pairing the Midland BTNEXT PRO to Bluetooth devices

The Midland BTNEXT PRO unit can be paired to other Bluetooth devices, like Pho-
ne, GPS Navigator or PMR446 Radio with built-in or external Bluetooth (dongle).
The pairing procedure must be done using the "Volume +" or the "Volume -" buttons.
› Pairing to the "Volume +" button: for Phone with music A2DP stereo, GPS Naviga-
tor with A2DP audio or external mono/Stereo A2DP dongle.
All devices paired to "Volume +" button has higher priority and will interrupt all the other
communication (like Intercom, FM Radio and Music).
› Pairing to the "Volume -" button: for Phone with music A2DP stereo, GPS Navigator
with A2DP audio or external mono/Stereo A2DP dongle.
All devices paired to "Volume -" button are always in active in background during the
Intercom communication.
VOL - Always in background
› Phone (HFP/A2DP Stereo)
› GPS (HFP/A2DP Stereo)
› Dongle (HFP/A2DP Stereo)
When a device is paired to the "Vol +" or "Vol –" buttons the "Phone" mode is activated.
Background feature
The audio connection on any device paired on "Vol-" button, even if it is stereo, is always
in background. In this way the Intercom communication will not be interrupted, for
example, by the GPS's street indication or other audio source. You can decide if the
audio from the "Vol -" connection is shared with other people when the intercom is open
30
VOL + High Priority
› Phone (HFP/A2DP Stereo)
› GPS (HFP/A2DP Stereo)
› Dongle (HFP/A2DP Stereo)
(public) or if it must be private (private).
To share the audio from "Vol -" with the intercom: long press the "Vol-" button the voice
will tell you "public"
To keep the audio from "Vol -" private: long press the "Vol-" button again the voice will
tell you "private"
Attention: By default the audio is private
The audio from "Vol -" has always lower priority against the Intercom, that means when
the intercom is open the audio is lowered by default to 50%. You can change this setting
using the BTUpdater PC Software
Pairing with one or two phones
The cellular phone can be paired to the "Vol +" or to the "Vol –".
When a phone is paired to the "Vol +" or "Vol-" the "Phone" mode is activated.
An incoming call has always the higher priority, that means all other communications will
be closed (Intercom, FM Radio, Music).
If another incoming call will arrive on the second phone, an alert sound will notify it.
WARNING!
In order to have the best performance with your mobile phone, it is suggested to keep it
as close as possible to your BT NEXT PRO unit, on the left side of your body and in the
upper pocket of your jacket if it's possible.
How to pair the Midland BTNEXT PRO to a Phone
To pair the Midland BTNEXT PRO to a Phone, you must first enter the setup mode:
1. Turn off the unit
2. Press and hold down the middle button about 7 sec., until the Red light is on perma-
nently.
3. Now press for 3 seconds the "Volume +" or "Volume -" button, the Blue and Red lights
will flash.
4. Enable the Bluetooth device search feature on your mobile phone
5. After some seconds, "Midland BTNEXT PRO" will be displayed on your mobile phone.
www.midlandeurope.com