Acura RLX Sport Hybrid 2020 Owner's Manual page 25

VEHICLE CONTROLS
n Exterior Lights
Rotate the switches on the lever to
operate the exterior lights. Push the
lever forward to turn on the high
beams. Return the lever to its original
position for low beams.
OFF: All exterior lights are off.
Turn on exterior lights except headlights.
AUTO: Turn on the automatic lighting feature. Headlights turn on or off
depending on ambient brightness when the vehicle is on.
Headlights automatically come on after the wipers are engaged
for a certain time. The headlights come on when you unlock a
door in dark areas with the headlight switch in AUTO.
Turn on all exterior lights including headlights.
*1
Turn fog lights on or off.
One-Touch Turn Signal
Use this quick and convenient method to
signal a lane change.
Lightly push the turn signal lever up or
down for an automatic three-blink
sequence.
For a continuous signal, push the lever up
or down until it locks into place.
42 |
Auto High Beam
The front sensor camera detects the light sources ahead of the vehicle such as
the lights of a preceding or oncoming vehicle, or street lights. When you are
driving at night, the system automatically switches the headlights between
low beam and high beam depending on the situation.
For the system to work properly:
• Do not place an object that reflects light on the dashboard.
• Keep the windshield around the camera clean. When cleaning the
windshield, be careful not to apply windshield cleanser to the camera lens.
• Do not attach an object, sticker or film in the area around the camera.
• Do not touch the camera lens.
If the camera receives a strong impact or requires repair, consult a dealer.
If you see the message "Some Driver Assist Systems Cannot Operate: Clean
Front Windshield", park your vehicle in a safe place. Wipe away debris
blocking the windshield, then start driving again. If the message remains even
after driving for a while with the clean windshield, have your vehicle checked
by a dealer.
If you see a message that the camera is too hot, use the climate control
system to cool the interior. Defroster mode will direct airflow toward the
camera.
n Automatically switching between high beam and low beam
When auto high beam is active, the headlights switch between high beam
and low beam based on the following conditions.
If you find the timing of beam changes inconvenient for driving, change the
beams manually.
Switching to high beam
All of the following conditions must be met before the high beams turn on.
*1 - If equipped
VEHICLE CONTROLS
| 43