Avaya 5900 Series Quick Start Configuration page 65

Ethernet routing switch
Hide thumbs Also See for 5900 Series:
Table of Contents

Advertisement

ipv6 mgmt address <WORD>
4. To assign or modify an out-of-band management IPv6 address for a switch, stack or unit,
enter the following command at the command prompt:
ipv6 mgmt address [switch | stack | unit <1–8>] <WORD>
Note:
You must configure the stack out-of-band management IPv6 address on the base unit.
Important:
Only one management default gateway can operate for each unit or stack. The out-of-
band management default gateway takes precedence over the in-band management
default gateway. Once an out-of-band management default gateway is configured, the
in-band management address is reachable only through a directly attached subnet for
the management VLAN.
5. To configure the default-gateway, enter the following command at the command prompt:
ipv6 mgmt default—gateway <WORD>
6. To configure a static route for the management port, enter the following command at the
command prompt:
ipv6 route <WORD> mgmt
ipv6 route <WORD> mgmt [cost <1–65535> | enable | preference <1–
255>]
7. To display the IPv6 address out-of-band management configuration, enter the following
commands at the command prompt:
show ipv6 mgmt address [switch | stack | unit <1–8>]
show ipv6 mgmt default—gateway
show ipv6 mgmt interface
8. (Optional) To configure the default out-of-band management IPv6 address, enter the
following command at the command prompt:
default ipv6 mgmt address [switch | stack | unit <1–8>]
9. (Optional) To configure the default out-of-band IPv6 management default gateway, enter the
following command at the command prompt:
default ipv6 mgmt default-gateway
10. (Optional) To configure the default IPv6 interface process-redirect on the switch, enter the
following command at the command prompt:
default ipv6 mgmt interface [ process-redirect ]
11. (Optional) To clear the out-of-band management IPv6 address, enter the following
command at the command prompt:
October 2015
Configuring an out-of-band management IPv6 address
Quick Start Configuration for Avaya ERS 5900 Series
Comments on this document? infodev@avaya.com
65

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5928gts

Table of Contents