Epson STYLUS SCAN 2500 Manual page 42

If the nozzle check page does not print satisfactorily (for example,
if any segment of the printed lines is missing), then you should
clean the print head as explained below. If the printout was
satisfactory, you are ready to print your first page.
Cleaning the print head
1. Make sure that the Operate light is on and that an ink out
message is not displayed on the LCD panel.
2. Hold down the
The Stylus Scan starts cleaning the print head and the
Operate light begins flashing. Print head cleaning takes
about one minute to complete.
c
3. When the Operate light stops flashing, print a few lines from
a document to confirm that the head is clean and to reset the
cleaning cycle.
If print quality hasn't improved after checking the nozzles and
cleaning four or five times, contact your dealer.
38
R
cleaning button for three seconds.
Caution:
Never turn off the Stylus Scan while the Operate light is
flashing. Doing so may damage the Stylus Scan.