Epson STYLUS SCAN 2500 Manual page 19

For Windows 98 with a USB connection
Before connecting the Stylus Scan to your Windows 98 computer
using the USB port, you must first install the Stylus Scan software.
This section guides you through the software installation and also
includes instructions on connecting the Stylus Scan to your
computer using the USB port. Follow the steps below.
Note:
Your computer must be a Windows 98 pre-installed model. You cannot
install or run the USB Printer Driver on a computer which is not
equipped with a USB port or which is upgraded from Windows 95 to 98.
1. Make sure the Stylus Scan is off, and that it is not connected
to your computer. Then turn on the computer and start
Windows 98.
Note:
If you turn on the Stylus Scan before turning on your computer, the
computer may detect the Stylus Scan and display the New Hardware
Found dialog box, or a similar wizard. If this occurs, click the Cancel
button to close the dialog box, and remove the USB cable. Then continue
with installation as described below.
2. Insert the EPSON Stylus Scan 2500 Software for Windows
CD-ROM in the CD-ROM drive. The Select Language dialog
box appears.
3. Select the language you want and click OK.
15