rEar hEaD rEsTs
1
Position for use
Raise the headrest as far as possible to
use it in the high position. Check that it
is correctly locked.
To remove the headrest
Raise the headrest as far as it will go,
then press button 1 and remove the
headrest.
3.30
2
To refit the headrest
Fit the rods into their housing and push
down the headrest until it locks to set
it to raised position. Check that the
bonnet is correctly locked.
folding positions 2 for the
headrest
Press the button 1 and lower the head-
rest completely.
when the headrest is set at the
lowest position, this is for storage
only. It should not be in this position
when a seat is occupied.
The headrest is a safety
component; check that it is
fitted and in the correct po-
sition. The top of the head-
rest should be as close as possible
to the top of the head.