Putting The Stop And Go Adaptive Cruise Control Function On Standby - Renault CLIO 2019 Vehicle User Manual

sToP anD go aDaPTivE crUisE conTrol
stopping the vehicle and
setting off
If the vehicle in front slows down the
system adapts its speed, to a complete
stop if necessary. The vehicle stops a
few metres from the vehicle in front.
The Stop and Start function can put the
engine on standby ➥ 2.8.
When the vehicle in front sets off again:
– if the stop does not exceed about
three seconds, the vehicle sets off
automatically without any action by
the driver;
– if the stop exceeds about three sec-
onds, you must apply the accelera-
tor pedal or press button 7 (RES/+) in
order for the vehicle to set off again.
The message "Press RES/+ or ac-
celerate" appears on the instrument
panel to confirm.
If the stop exceeds about three min-
utes, the electronic parking brake is
automatically applied and the Stop
and Go adaptive cruise control is de-

activated. The warning light disap-
pears to confirm that the function is de-
activated.
2.98
(6/13)
Putting the function on
standby
You can set the function to standby
when:
– you press switch 4 (0);
– you apply the brake pedal while the
vehicle is moving.
The function is deactivated by the
system if:
– you put the gearbox in P, r or n;
– you unbuckle the driver's seatbelt;
– you open one of the opening ele-
ments;
– you press the engine start/stop
button;
– the slope is too steep;
– the vehicle speed is above 112 mph
(180 km/h);
– certain driving aids and correction
devices are triggered (active emer-
gency braking, ABS, ESC, etc.)
4
7
In all circumstances, the standby is con-
firmed when the warning lights appear
in grey and the message "Adaptive
Cruise Ctl Disconnected" appears on
the instrument panel.
Putting the Stop and Go
adaptive cruise control in
standby or switching it off
does not cause a rapid re-
duction in speed: you must brake
by applying the brake pedal if nec-
essary.