Operation; Nc4 Layout; On/Off And Voltage Sensitivity - Martindale Electric NC4 Instruction Manual

3. OPERATION

3.1 NC4 Layout

1
2
3
1
Test tip for voltage test
2
Torch
3
LED illumination area
4
Hand grip area
5
On/Off and voltage sensitivity range button
6
Torch button
7
Battery compartment end cap
3.2 ON/OFF and Voltage Sensitivity Range
Button
Pressing the ON/OFF button (5) for 1 second
will turn on the NC4. The red LED in the LED
illumination area (3) will flash at a rate of once a
second to indicate the unit is activated.
The NC4 will default to the 50 to 1000V voltage
sensitivity range.
To change the voltage sensitivity range to 12V to
1000V, press the voltage sensitivity range button
(5) for less than 1 second. The red LED in the LED
illumination area (3) will now double flash at a rate
of once a second.
To power off the unit press the ON/OFF button (5)
for at least 2 seconds. The flashing red LED will
cease.
5
6
4
7
5