Teufel Ultima 800 DiY Edition Technical Description And Assembly Instructions page 8

4. Mounting the cable distributor
4.1 Use one wood screw to mount each circuit board
for the two cable distributors on the right inside
wall (viewed from the back). The holes have
been predrilled. The cable distributor with the 4
connector cables should be facing down.
4.2 Run the cable with the plug from the bottom ca-
ble distributor through the hole in the intermedi-
ate panel and connect the plug with the counter
piece from the other cable distributor.
5. Laying the cables
5.1 Lay all cables as shown in the wiring diagram on
the right and let the cable ends protrude out of
the openings for the speakers and the connector
terminal.
The designations on the circuit boards have the
following meaning:
TW Tweeter
MID Midrange
WF Woofer
IN Input
8 • Ultima 800 DiY assembly set
Cross-slot PH2
Cable distributor with 3
connector cables for the
upper passive low-range
speakers
Cable distributor with 4
connector cables for the
bottom passive low-range
speakers
2 wood screws
High-range speaker
(blue)
Mid-range speaker
(green)
Active low-range speak-
er (red)
Connector terminal
Tweeter
blue
Midrange
green
crossover
red
Aktive
red
Aktive
crossover
Passive
Front
WF
red marking
IN
Passive
Cable distributor
with 3 connector
cables
Large
Passive
Cable distributor
Small
Passive
with 4 connector
cables
Connector
terminal
Back
TW
blue
MID
marking
green
marking
IN