Displaying And Maintaining Hvrp Configuration; Hvrp Configuration Example - H3C S9500 Series Operation Manual

Operation Manual – HVRP
H3C S9500 Series Routing Switches
A switch located on the intersection point of the intersected rings must be configured to
age all the VLANs.
Follow these steps to configure the system to age all the VLANs:
Enter system view
Configure the system to age all
the VLANs

1.3 Displaying and Maintaining HVRP Configuration

Display brief HVRP information
Display detailed information on
HVRP
Display local VLAN information
Display information on VLANs
that are actually allowed to
pass through the ports
Enable HVRP error debugging
Enable VLAN debugging of
HVRP

1.4 HVRP Configuration Example

I. Network requirements
The topology is a single ring network.
STP is enabled network wide, with Switch 1 as the root bridge.
Switch 1, Switch 2, Switch 3, Switch 4, and Switch 5 are all Layer 2 switches.
Switch 1 is the root bridge and the rest switches connect with Layer 3 devices via
Switch 1.
The link between Switch 3 and Switch 4 is blocked by STP.
User 1 and user 4 are household users who only want to visit the Internet through
Switch 1; user 2 and user 3 are enterprise users, and therefore in addition to
visiting the Internet, they also want to visit each other.
Users refer to all users connected with the switches, including terminal users and
DSLAM users.
To do ...
To do ...
Use the command ...
system-view
hvrp vlan-age all
Use the command ...
display hvrp brief
display hvrp verbose
display hvrp local-vlan
display hvrp port-vlan
debugging hvrp error
debugging hvrp info
1-9
Chapter 1 HVRP Configuration
Remarks
—
Optional
Remarks
Available in any view
Available in any view
Available in any view
Available in any view
Available in user view
Available in user view