Hvrp Configuration Task - H3C S9500 Series Operation Manual

Operation Manual – HVRP
H3C S9500 Series Routing Switches
The link between Switch 3 and Switch 4 is blocked by STP.
The clients illustrated in
including terminal clients and DSLAM clients.
In practice, Switch 1 can be either a Layer 2 or a Layer 3 device.
II. Multi-Ring Networks
Figure 1-3 An HVRP-supported multi-ring network
Features of multi-ring networks:
MSTP is enabled network wide, with each ring corresponding to an MSTP
instance. All the devices belong to the same domain.
Switch 1-2, Switch 1-3, Switch 1-4, Switch 1-5, Switch N-2, Switch N-3, Switch
N-4, and Switch N-5 are all Layer 2 switches. Switch 1 is the root bridge of all
instances and the other devices connect to Layer 3 devices via Switch 1 (Switch 1
can be either a Layer 2 or a Layer 3 device).

1.2 HVRP Configuration Task

Complete the following tasks to configure HVRP:
Configuring HVRP
Configuring HVRP Time Parameters and Attributes
Configuring VLAN Attributes of HVRP
Figure 1-2 include all clients connected with the device,
1-5
Chapter 1 HVRP Configuration