Configuring Vlan Attributes Of Hvrp - H3C S9500 Series Operation Manual

Operation Manual – HVRP
H3C S9500 Series Routing Switches
Caution:
The VLAN registration timer must be smaller than the registered-VLAN aging
interval. It is recommended that the latter be at least three times the former.
On a ring topology, all devices must have the same VLAN registration timer.

1.2.3 Configuring VLAN Attributes of HVRP

The VLAN attribute configuration tasks for HVRP include:
Configuring a permanent VLAN
Configuring the system to age all the VLANs
VLANs on a HVRP-enabled designated port can be aged out, while permanent VLANs
will never be aged out. Make sure all the specified VLANs are created before
performing the configurations below.
I. Configuring a permanent VLAN
The VLAN(s) on an HVRP port may be aged out while a permanent VLAN will never be
aged out.
You cannot configure a VLAN as a permanent VLAN unless the VLAN has been
created.
Follow these steps to configure a permanent VLAN:
Enter system view
Configure permanent
VLANs
Caution:
You are recommended to configure a VLAN with an IP address as a permanent VLAN.
II. Configuring the system to age all the VLANs
In a single-ring network or multi-ring network, you can configure the system to age all
VLANs or only local VLANs. The default configuration is recommended. You can use
the hvrp vlan-age all command to configure the system to age all the VLANs.
To do...
system-view
hvrp permanent-vlan
vlan-id [ to vlan-id ]
Use the command ...
1-8
Chapter 1 HVRP Configuration
Remarks
—
Optional
By default, no permanent
VLAN exists.