Operation Manual – HVRP
H3C S9500 Series Routing Switches
1.2.1 Configuring HVRP
HVRP can be enabled in system view or in Ethernet port view. When HVRP is disabled
globally in system view or disabled in Ethernet port view, all the other HVRP-dependent
configurations will be disabled as a result.
I. Configuration Prerequisites
HVRP-enabled ports must be Trunk ports.
STP is enabled globally.
GVRP is disabled globally.
II. Configuring HVRP
Follow these steps to configure HVRP in system view:
Enter system view
Enable HVRP
Follow these steps to configure HVRP in port view:
Enter system view
Enter Ethernet port view
Enable HVRP
To do ...
system-view
hvrp enable
To do ...
system-view
interface interface-type
interface-num
hvrp enable
Use the command ...
Use the command ...
1-6
Chapter 1 HVRP Configuration
Remarks
—
Required
By default, HVRP is
disabled globally.
Remarks
—
—
Required
By default, HVRP is
disabled.