Kwh Meter Hardware Functions - E-Mon D-Mon Class 1000 Installation Instructions Manual

CLASS 1000 METER

6.3 KWh Meter Hardware Functions

IDR Jack
Calibration Jack
Error LED
Meter Pulse LED
Power On LED
Pulse Output
The Main circuit board is located inside the meter enclosure.
MAIN
POWER
TERMINAL
BLOCK
62-0388-01
8-pin RJ-45-used to connect kWh meter to the E-
Mon Energy automatic meter reading system.
Connector J11 is for factory calibration only, and is
not a user accessible port. Silicon plug is not to be
removed.
When lit, indicates that the current sensor is
backwards or on the incorrect phase.
Blinks to show the meter load. Blink rate increases
with load.
When lit, indicates power to meter is on.
Optically isolated output pulse for connection to
BAS or peripheral equipment.
PULSE OUTPUT
IDR JACK
Fig. 14. Hardware Functions
22
CALIBRATION
JACK
SEE
DESCRIPTION
ABOVE
POWER
ON LED
METER
PULSE LED
ERROR
LED
HEADER
CONNECTOR
CURRENT
SENSORS
M33212