Connecting Peripheral Equipment - Siemens SIMOTION P320-4 E Manual

Connection

6.5 Connecting peripheral equipment

6.5 Connecting peripheral equipment
Note
Observe suitability for industrial applications
Only connect I/O devices that are suitable for industrial applications in accordance with
EN IEC 61000-6-2.
Note
I/O devices capable of hot-plugging (USB)
Hot-plug I/O devices (USB) may be connected while the PC is in operation.
NOTICE
Non-hot-plug I/O devices
I/O devices that do not support hot-plugging may not be connected until the device is powered
down. Strictly adhere to the specifications for peripheral equipment.
Note
Wait at least ten seconds before you reinsert USB devices.
Note that the EMC immunity of standard USB devices is designed only for office environments.
These USB devices are appropriate for handling commissioning and service tasks. You may
only use USB devices that are suitable for industrial applications. The USB devices are
developed and marketed by the respective supplier. The respective product supplier provides
support for the USB devices. The manufacturer's terms of liability shall apply.
Note
The connected or built-in I/Os, such as USB drives, should not introduce a counter EMF into
the device.
Reverse voltages exceeding 0.5 V to ground that are generated by connected or installed
components may prevent proper operation of the device or lead to its destruction.
80
SIMOTION P320-4 E / P320-4 S
Manual, 01/2015