Installation Notes - Siemens SIMOTION P320-4 E Manual

5.3

Installation notes

Note the following:
● The SIMOTION P320-4 is approved for operation in closed rooms only.
● For installation in a control cabinet, observe the SIMATIC installation guidelines and
applicable DIN/VDE requirements or other applicable country-specific regulations.
● When the device is used in the area of Industrial Control Equipment according to UL508,
note that the device is classified as "Open Type". The installation of the device in a housing
according to UL508 is therefore a mandatory requirement for approval or operation in
according to UL508.
Securely fastening the SIMOTION P320-4
NOTICE
Insufficient load carrying capacity
If the wall it is mounted on does not have a sufficient load-bearing capacity, the device may
fall and be damaged.
Ensure that the mounting surface on the wall can bear four times the total weight of the device,
including fixing elements.
NOTICE
Incorrect fixing elements
The device may not be securely fitted if you use dowels and screws other than those specified
below for mounting. The device can fall and may be damaged.
Use only the dowels and screws specified in the following table.
SIMOTION P320-4 E / P320-4 S
Manual, 01/2015
Installation/mounting
5.3 Installation notes
69