HP ProLiant SL170s G6 Maintenance And Service Manual page 75

Table 11
POST error messages
Error code
608h
609h
611h
613h
626h
628h
630h
631h
633h
643h
644h
Error message
Fan Solution Not Sufficient!
Critical Failure Detected - System
Shutting Down in xx seconds!
Temperature Violation Detected!
Waiting 5 minutes for system to
cool. Press ESC Key to resume
booting without waiting for the
system to cool. Warning: Pressing
ESC is NOT recommended as
system may shutdown unexpectedly.
Recheck Temperature in xxx
seconds!
System Event Log full
Power Supply Mismatch Error -
System Halted
BMC Recovery Jumper Set or BMC
Firmware corrupted!
Inlet Ambient Sensor Cable Did Not
Get Plugged or Came Loose!
Power Supply 1 Failure or Power
Supply Unplugged!
Power Supply 2 Failure or Power
Supply Unplugged!
Power Supply 3 Failure or Power
Supply Unplugged!
Invalid or Unknown Chassis
Detected!
Upgrade System BIOS or Check
Hardware Configuration!
Power Supply 4 Failure or Power
Supply Unplugged!
Description/corrective action
If one or more fan are missing, this
message will appear with 'system
fan x missing' together.
If system detects one or more
temperature sensor over heat.
If system cannot store any more
event log, this will appear at post.
When different vendor power
supplies are installed, this appears
and the system halts.
When Jumper J53 is installed or
BMC firmware is corrupt, this
appears.
When Inlet Ambient sensor board is
uninstalled or the sensor board
cable is loose, this appears and the
fan runs at full speed.
When power supply 1 is installed
and the power cable is
disconnected or the power is failed,
this appears.
When power supply 2 is installed
and the power cable is
disconnected or the power is failed,
this appears.
When power supply 3 installed and
the power cable is disconnected or
the power is failed, this appears.
When Chassis ID is not defined, this
appears.
When power supply 4 is installed
and the power cable is
disconnected or the power is failed,
this appears.
Diagnostic tools and setup utilities 75