HP ProLiant SL170s G6 Maintenance And Service Manual page 67

Figure 50 IDE configuration submenu
•
SATA Controller Mode has four options: Compatible, RAID, AHCI and Disabled.
•
If Compatible mode is selected then the drive mapping will be:
○
Port0 – Primary IDE Master
○
Port1 – Secondary IDE Master
○
Port2 – Primary IDE Slave
○
Port3 – Secondary IDE Slave
•
For other modes, the drive mapping will be assigned by ports starting from Port0 and going to
Port5.
•
For more information about SATA Controller Mode, see below table.
Field Options
SATA Controller Compatible
Mode
RAID
AHCI
Disabled
Description
Legacy Native mode, supports up to 4 drivers.
Only available on systems with an embedded software RAID option
ROM.
This is the DEFAULT if NCQ Mode requires that AHCI also be
Enabled. Otherwise, legacy SATA Native Mode is the DEFAULT as
previously specified. This is the default value.
SATA controller is Disabled and does not appear in the standard
boot order list.
Diagnostic tools and setup utilities 67