Receiving The Data - Sony RM-AV2500 Operating Instructions (primary manual) Operating Instructions Manual

Transferring Data between Remote
Commanders (continued)

Receiving the data

This Commander can receive the data of
another Sony RM-AV2500.
To receive the all data from
another remote commander
3
4
2
1
While pressing COMMANDER
OFF, press CHANNEL – and
VOLUME –.
40
2
Press the r button.
R: Transfer data
r: Receive data
3
Press the 1 key.
1: All data of the Commander
2: Data of a Component Select button
1
4
Press the ENTER key.
As the data is received, the
corresponding component name stays
lit. If the all data have been
successfully received, the backlight of
the display turns off.
Notes
• If the Commander is not ready for
receiving the data, press CLEAR key, then
OK key to clear the learned signal on all
or one of the Component Select buttons.
• If "NG" appears during data transfer, go
back to Step 3 and continue the operation
or press COMMANDER OFF to stop the
operation. If you continue the operation,
you have to set the sending remote
commander again to send data.