Sony RM-AV2500 Operating Instructions (primary manual) Operating Instructions Manual page 38

Transferring Data between Remote
Commanders (continued)
1
Place the RM-AV2500 head to
head with another remote
commander.
Another remote commander
about 2 – 4 inches
(5 – 10 cm) away
2
While pressing COMMANDER
OFF, press CHANNEL – and
VOLUME –.
3
Press the R button.
R: Transfer data
r: Receive data
38
4
5
6
RM-AV2500
Note
Be sure that the receiving remote commander is
ready to receive data.
Press the 1 key.
1: All data of the Commander
2: Data of a Component Select button
Confirm that the receiving remote
commander is ready for data.
(To set the receiving commander,
follow the procedure on page 40.)
Press the "ENTER" key.
As the data is transferred, the
corresponding component name goes
off. If the all data has been
successfully transferred, the backlight
of the display turns off.
Note
If "NG" appears while sending the data, go
back to Step 5 and continue the operation
or press COMMANDER OFF to stop the
operation.