Troubleshooting - Sony RM-AV2500 Operating Instructions (primary manual) Operating Instructions Manual

Troubleshooting

If you have problems setting up or using the Remote Commander, first check the
batteries (page 6), then check the items below.
Symptom
You cannot operate the
components.
Remedy
• Go closer to the component. The maximum operating distance is
approximately 32.8 ft. (10 m).
• Check that you are aiming the Commander directly at the compoent,
and that there are no obstructions between the Commander and the
component.
• Turn on the components first, if necessary.
• Check that the component has infrared remote capability. For example,
if your component did not come with a remote commander, it probably
is not capable of being controlled by a remote commander.
• You have assigned a different component to the Component Select
button. Check the component assigned to that button and the
component code.
• If you do not use the commander for a long time, LCD panel response
may become erratic. In this case, follow the procedure below:
1 While pressing COMMANDER OFF, press MENU and EXIT.
A bullet mark will appear in the bottom left of the LCD panel.
2 Press the next target that appears in the top right of the LCD panel.
3 Press the square that appears in the center of the LCD panel.
A beep sounds to confirm the setting.
Continued
55