Reassembly - Toro TimeCutter Z Series Service Manual

TRANSAXLE

Reassembly

IMPORTANT: Before installing a new transaxle,
check the oil level and check the torque on the
nut retaining the input pulley. Torque to 30 - 35
ft. lbs. (40.7 N·m - 47.5 N·m).
Use a jack to lift the transaxle into the chassis.
Carefully guide it into position so that the cooling
fan does not catch on the chassis and the
bypass rod is properly positioned in the lever.
Insert the vent hose through the slot provided for
it in the frame.
5
Install the two axle bolts, washer, and nuts to the
frame. Do not tighten the bolts. Reinstall the
rest of the bolts, washers, and nuts in the lower
hydro plate. If the plate was completely
removed, make sure the lip of the plate is
pointing to the front and down. Tighten the
transaxle bolts and nuts following the sequence
shown in the photo. Torque the bolts and nuts to
200 in. lbs. (22.6 N·m)
5 - 10
0702-0516
0702-0515
0702-0513
TimeCutter™ Z Service Manual
5
2
3
1
4