Z18-52 - Toro TimeCutter Z Series Service Manual

Maintenance Schedule (Z18-52)
Maintenance Procedure
Change the engine oil
Check the engine oil level
Check the safety system
Clean the air intake screen
Clean the mower housing
Check the cutting blades
Grease all lubrication points
1
Oil the linkage bushings
Service the foam air cleaner
Check the belts for wear/cracks
Check the battery electrolyte
Check the tire pressure
Service the paper air cleaner
Change the engine oil
Check the spark plug(s)
Change the oil filter
Replace the fuel filter
Replace the paper air cleaner
Clean the engine shrouds and cooling fins
Before Storage:
• Perform all maintenance procedures listed above.
• Drain the fuel tank.
• Charge the battery and disconnect the battery cables.
• Paint any chipped surfaces.
1
More often in dusty, dirty conditions
IMPORTANT: Refer to your engine operator's manual for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the
engine and seriously injury you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark
plug(s) before you do any maintenance. Set the wire aside so that it does not
accidentally contact the spark plug.
TimeCutter™ Z Service Manual
1
1
1
1
1
CAUTION
MAINTENANCE
Service Interval
After first use
Each use
Every 5 hours
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 300 hours
1 - 9
1c