Toro TimeCutter Z Series Service Manual page 18

SPECIFICATIONS
Specifi cations cont.
Engine:
High Idle
Low Idle
1b
Horse Power
Cubic Centimeter's (cc's)
Fuel
Oil Capacity
Charge coil
Construction:
Front Frame
Rear Frame
Frame Assembly
Deck
Fuel System:
Capacity
Traction System:
Transaxles
Transaxle Drive
Ground speed forward
Ground speed reverse
Transport rods
Attachment Drive:
Clutch
Type
A1-14
ZX 480
Briggs & Stratton Intek OHV, 441577
3400 + 100 RPM
N/A
N/A
725 Dispacement
Unleaded Gasoline 87 octane min.
2 qts. (1.9 L)
12v - 16 amp
Welded 1x2x.120" structural steel tube
Welded 7 & 10 ga. High strength steel
Front & rear frames bolted together.
Right side discharge, 48" cut, three
blade mid-mounted rotary. Drawn 12
gauge steel deck with gauge reinforced
plate and welded mounting brackets and
gauge.
Single fuel tank fender type mounted on
the left side.
5 Gallons (18.9 L)
Fuel tank shut off
In-line fuel fi lter
Twin Hydro-Gear IZT Hydrostatic Trans-
axles with charge pumps & shock valves.
Belt Drive with self-tensioning system
Infi nite, 0 to 7.0-MPH (11.3-km/hr)
0 to 3.4-MPH (5.5-km/hr)
Allows unit to be moved without engine
running.
Electric
Vertical Drive with Single Deep B-Groove
Pulley
ZX 525
Kawasaki FH58V OHV
3400 + 100 RPM
1400 RPM
N/A
585 Dispacement
Unleaded Gasoline 87 octane min.
1.9 qts. (1.8 L)
12v - 13 amp
Welded 1x2x.120" structural steel tube
Welded 7 & 10 ga. High strength steel
Front & rear frames bolted together.
Right side discharge, 44" cut, three blade
mid-mounted rotary. Drawn 12 gauge
steel with welded mounting brackets and
gauge wheel brackets. Frame supported.
Single fuel tank fender type mounted on
the left side.
5 Gallons (18.9 L)
Fuel tank shut off
In-line fuel fi lter
Twin Hydro-Gear IZT Hydrostatic Trans-
axles with charge pumps & shock valves.
Belt Drive with self-tensioning system
Infi nite, 0 to 7.0-MPH (11.3-km/hr)
0 to 3.4-MPH (5.5-km/hr)
Allows unit to be moved without engine
running.
Electric
Vertical Drive with Single Deep B-Groove
Pulley
TimeCutter ZX Service Manual